HUSQVARNA 394 to 395 aftermarket Meteor cylinder kit made in Italy Warranty from manufacture problems is 1 year

After doing several recent rebuilds, I found a few things that I needed to add to this kit to make the rebuild smother and trouble free.

I have added a carb kit as you need to get into the carb to fit the impulse elbow. so rekit it at the same time.

I also added the exhaust plate, as most of these are beat up and unusable.

The picture below has all the parts in this kit.

This is a 56mm cylinder nikasil plated kit for the Husqvarna 395 cylinder with all the parts and instructions to make it work on the 394

I know what it takes to do a good rebuild. I put together this complete part kit. I have added all the parts you need for a good rebuild. It allows you to fit a 395 cylinder to a 394 saw. If you need crank seals, see below.

You get all the parts in the below pictures. Use this kit for fitting a 395 cylinder to your 394. If you just need the 395 cylinder see below.

USA PRICE 210.00

SHIPPING TO THE WOURLD 255.00

CRANK SHAFT SEALS FOR THE 394 OR 395 ONE SET 22.00

If you encounter any problems along the way, I am here to help you through it.

To avoid this happening again, use fresh premium gas which is less than 60 days old. Use an oil mix rated FD and a gas can with a tight seal. This will insure the least amount of water dissolved in the gas and the most lubrication possible.

SHIPPING FREE TO THE USA

HERE IS MY VIDIO ON HOW THIS IS DONE